Chemical cleaning m
In silicone rubber extruder machinery industry, its mechanical equipment is very much, and ...
The extrusion moldi
Silicone extruder is tire production process is necessary and required rubber machinery equ...
Silica gel extruder
In the rubber machinery industry, the silicon extruder is a more common and more commonly u...
Use of extruder hea
CONDAT forging lubricants with unique ingredients designed to help create companies in chal...
The daily failure inspection and maintenance method of 65 rubber sleeve extruders:
1, 65 rubber sleeve reboots - before the second start, remove the remaining debris from the machine room and reduce the resistance at startup.
Open the inertia mask and the pulley mask regularly and periodically remove the putty from the bottom of the flange.
Check the cutting machine screw for a regular check.
The bearing of the extruder should be lubricated by timing, which keeps the bearings well lubricated.
The cutting edge should be checked frequently and the cutting edge of the cutting tool should be checked to minimize the damage caused by the blunt lack of the blade.
Any damage should be replaced in time.
3, in the course of everyday use, should be settled extrusion machine equipment of wire and cable in ventilated place, but also to fully guarantee the motor work can get heat, so can not only prolongs the service life of mechanical, but also the performance of the equipment.
In addition, the machine should be kept well grounded.
The extruder replacement parts -- when replacing the tool, pay special attention to the gap between the knife and the fixed knife: 30HP above crusher.
2MM is the most suitable, 30HP under 0.
Best 8 mm.
The thinner the recovery material, the clearance can be increased appropriately.
The regular maintenance of cable extruder: the extruder is used for a period of time to do a thorough examination and see if the parts can be safely and reliably run.
The extruder will have to be swept away for a long period of time without using it.
